New standards in pipe beveling machines


GERIMA sets new standards in pipe beveling machines.

With the new clamping concept GERIMA-MMP the GERIMA hand bevel milling machines can now also be used as portable pipe end preparation machines quickly and effectively locally.

There are currently three variants are offered:

Type    Clamping    Ø-Pipe      Thickness    Bevel

MMP-S  Pipe outside   76-300mm up to 16mm  up to 20mm

MMP-M  Pipe inside    200-720mm up to 16mm  up to 20mm

MMP-L   Pipe wall       from 76mm  up to 16mm  up to 20mm

The clamping systems are tightened around the pipe or on the pipe wall. The hand bevel milling machines are connected with the clamping device and connected with a slide to the pipe edge. The bevel angle is defined by changeable milling heads with a corresponding bevel angle. The milling units are spring loaded and copy over a copying roll on the pipe wall the tube contour. Thus, a very good bevel quality is produced with accurate land " lang="EN-US">The machines / clamping systems have been developed for use both in production as well as on the site. For disposal are electric and pneumatic milling machines.


Exhibitor Data Sheet