02/05/2014
GERIMA sets new standards in pipe beveling machines.
With the new clamping concept GERIMA-MMP the GERIMA hand bevel milling machines can now also be used as portable pipe end preparation machines quickly and effectively locally.
There are currently three variants are offered:
Type Clamping Ø-Pipe Thickness Bevel
MMP-S Pipe outside 76-300mm up to 16mm up to 20mm
MMP-M Pipe inside 200-720mm up to 16mm up to 20mm
MMP-L Pipe wall from 76mm up to 16mm up to 20mm
The clamping systems are tightened around the pipe or on the pipe wall. The hand bevel milling machines are connected with the clamping device and connected with a slide to the pipe edge. The bevel angle is defined by changeable milling heads with a corresponding bevel angle. The milling units are spring loaded and copy over a copying roll on the pipe wall the tube contour. Thus, a very good bevel quality is produced with accurate land " lang="EN-US">The machines / clamping systems have been developed for use both in production as well as on the site. For disposal are electric and pneumatic milling machines.