The e-clean process developed by STAKU not only needs a fractional amount of the usual treatment time but also achieves by far better cleaning results.
degreasing of drawing agents / stearates
pickling of wire rod scales
only a fraction of the usual treatment period necessary
far better cleaning results
lower production costs
During the electrolytic cleaning continuous current flows to any spot of the metal surface and generates small hydrogen an dioxygen blisters according to polarization. The pollutant particles are blast away from the surface by the emerging gas pressure and cause thereby a precision cleaning of the surface. Consequently electrolysis is especially suitable in cases you need very clean surfaces.
Product category: Coating, plant engineering and construction
Complete inline devices for single-wire and multi-wire treatment
Compared to the conventional phosphating process the STAKU e-phos process offers essential advantages in its inline devices, such as very short treatment periods, lower consumption of chemicals and lower operating temperature. This allows reduction of operating costs and a considerable increase of productivity at the same time.
very uniform and fine crystalline phosphate layer with best sliding property and compression strength
very short treatment periods
low consumption of chemicals and low energy costs
no waste water to neutralize and no creation of iron-phosphate-sludge
Patented processes for surface pre-treatment and finishing
Our competence is based on decades of experience in developing galvanic processes for pre-treatment and refinement of metallic semi-finished products.
Our specialist staff in the laboratory is working permanently on the improvement of existing processes as well as the development of new processes for optimal solutions, which are realized in our engineering department. Finally in our workshops STAKU builds complete production devices.